Installation manual
CNC 8055
CNC 8055i
ACCESS TO INTERNAL CNC VARIABLES
13.
SOFT: V02.2X
·561·
Variables associated with telediagnosis
MEMTST
It returns the result of the memory test. Each data uses 4 bits. The text is successful if the least
significant bit of each data is set to 1. There is an error if the least significant bit of any data is other
than 1.
Bit 30 stays at "1" during the test.
NODE
It returns the number of the node used to configure the CNC in the Sercos ring.
VCHECK
It returns the checksum of the code for the software version installed. It is the value appearing on
the code test.
IONODE
It returns in 16 bits the position of the "ADDRESS" switch of the CAN of the I/O. If it is not connected,
it returns the value 0xFFFF.
IOSLOC
They may be used to read the number of local digital I/O available.
IOSREM
They may be used to read the number of remote digital I/O available.
Bits Test
30 Test status
... ...
... ...
19 - 16 Caché
Bits Test
15 - 12 Sdram
11- 8 HD
7 -4 Flash
3 - 0 (LSB) Ram
Bit Meaning
0 - 15 Number of inputs.
16 - 31 Number of outputs.
Bit Meaning
0 - 15 Number of inputs.
16 - 31 Number of outputs.
To Next Page
Loading...
