Installation manual
CNC 8055
CNC 8055i
ACCESS TO INTERNAL CNC VARIABLES
13.
SOFT: V02.2X
·569·
Other variables
LONGAX
This variable can only be used at the mill model. It returns the number according to the programming
order corresponding to the longitudinal axis. This will be the one selected with the G15 function and
by default the axis perpendicular to the active plane, if this is XY, ZX or YZ.
Example:
If the CNC controls the X, Y, Z, U, B, C axes and the U axis is selected.
(CNCRD LONGAX, R22, M34) assigns the value of 4 to register R22.
MIRROR
Returns in the least significant bits of the 32-bit group, the status of the mirror image of each axis,
1 in the case of being active and 0 if not.
The axis name corresponds to the number according to the programming order for them.
Example: If the CNC controls axes X, Y, Z, U, B, C, axis 1=X, axis2=Y, axis3=Z, axis4=U, axis5=B,
axis6=C.
SCALE
It returns the general scaling factor being applied. It will be multiplied by 10000.
SCALE(X-C)
Returns the specific scaling factor of the indicated axis (X-C). It will be multiplied by 10000.
ORGROT
This variable can only be used at the mill model. It returns the rotation angle of the coordinate system
currently selected with G73. Its value in 0.0001 degree units.
PRBST
Returns probe status.
0 = the probe is not touching the part.
1 = the probe is touching the part.
CLOCK
Returns the time in seconds indicated by the system clock. Possible values 0..4294967295.
TIME
Returns the time in hours-minutes-seconds format.
(CNCRD TIME, R100, M102) ; assigns the time to register R100. For example, if the time is 18h
22m 34s, R100 will show 182234.
DATE
Returns the date in year-month-day format.
(CNCRD DATE, R101, M102) ; assigns the date to register R101. For example: if the date is April
25th 1992, R101 = 920425.
CYTIME
It returns the amount of time (in hundredths of a second) elapsed executing the part. It ignores the
time the execution has been interrupted. Possible values 0..4294967295.
The CNC will consider the execution of the program finished after executing its last block or after
executing a block containing an M02 or M30 miscellaneous function.
Bit 8Bit 7Bit 6Bit 5Bit 4Bit 3Bit 2Bit 1Bit 0LSB
Axis 7 Axis 6 Axis 5 Axis 4 Axis 3 Axis 2 Axis 1
To Next Page
Loading...
