Installation manual
CNC 8055
CNC 8055i
CUSTOMIZABLE SCREENS
15.
SOFT: V02.2X
·593·
Configuration file
15.1 Configuration file
It is a program which describes the operating characteristics of the graphic elements of the screen.
Set general parameter "CFGFILE (127)" with the number of the program for the configuration file:
The configuration file is a CNC program edited in high level language (configuration language) which
is described later on. It may be edited both at the CNC and at a PC.
It may be in the user RAM and in the hard disk (KeyCF). If it is in both places, the one located in
user RAM will be used. It is recommended to store it only in the hard disk (KeyCF) once it has been
fully debugged.
The configuration file must contain all the information regarding all the screens being customized.
When editing a screen, the CNC overlaps the OEM screen over the standard CNC screen. The
DISABLE instruction of the configuration file serves to indicate which of the standard screen areas
are eliminated.
Example: Standard screen + OEM screen + Disable 1
Both screens are overlapped; but "Disable 1" indicates that the area 1 of the standard screen is not
displayed. Therefore:
Next, all the screens that may be customized will be shown and the nomenclature to be used in the
configuration file. Numbers 1, 2, 3, 4 and 5 indicate the areas each screen is divided into.
Standard screen OEM screen
[JOG]
JOG mode - Actual
[JOGAFL] JOG mode - Actual and Following error
To Next Page
Loading...
