CNC 8055
CNC 8055i
SOFT: V02.2X
16
·607·
CONFIGURABLE WORK MODE
The CNC offers a work mode that may be configured by the machine manufacturer. The basic screen
provided by Fagor permits controlling the axes, the tool and the spindle.
In the configurable work mode, the manufacturer (OEM) can:
• Configure, partly or completely, the basic screen provided by Fagor.
• Create diagnosis screens.
• Create screens to consult and/or modify internal variables of the CNC, PLC or drive.
• Create screens for the operator to set zero offsets, etc.
Since all the OEM screens have a subroutine associated, they can also create OEM cycles to:
• Consult inputs and outputs.
• Adjust the machine axes.
• Manage tool magazines.
• Manage external devices.
•etc.
The OEM machining canned cycles may even be used to machine parts. A machining operation
may be repeated as often as you wish, but it cannot be stored in memory.
With the keystroke sequence [SHIFT] [ESC] , it is possible to switch from M/T mode to configurable
mode and vice versa.
Depending on the model, when accessing the configurable work mode, the CNC shows the following
screen:
The way to operate with either model is very similar. If any of the features described here is not
common to both models, it will clearly indicate which model it corresponds to.
These screens may be customized entirely or by areas. See "15.1 Configuration file" on page 593.
M model T model
To Next Page
Loading...
