·608·
Installation manual
CNC 8055
CNC 8055i
16.
CONFIGURABLE WORK MODE
SOFT: V02.2X
The screen provided by Fagor contains the following information:
1. Clock.
2. This window may show the following data:
SBK When "single block" execution mode is selected.
DNC When the DNC mode is active.
P... Number of the program currently selected.
Message; «In position» - «Execution» - «Interrupted» - «RESET».
PLC messages.
3. This window shows the CNC messages.
4. The window provided by Fagor shows the position of the axes (those of the auxiliary axes
highlighted) and the real spindle rpm (S).
5. The window provided by Fagor shows the axis feedrate (F) currently selected and the % of F
being applied.
6. The window provided by Fagor shows the tool number (T) and the tool offset (D). If the tool
number and offset number are the same, the CNC will not show the "D" value.
The T model also shows the graphic representation for the location code (shape) associated
with the tool.
7. The window provided by Fagor shows the associated spindle speed (S), the % being applied,
the selected turning direction and the active spindle gear.
The T model also shows the maximum rpm and the "CSS" value when working at Constant
Surface Speed.
8. This window shows the help texts associated with the OEM screens. Refer to the WINDRAW55
manual.
9. Reserved.
To Next Page
Loading...
