Fagor CNC 8055i FL EN - Chapter 16 Configurable Work Mode; Axis Control

Installation manual
CNC 8055
CNC 8055i
CONFIGURABLE WORK MODE
16.
SOFT: V02.2X
·609·
Axis control
16.1 Axis control
When accessing the customizable mode, the CNC assumes the work units "mm or inches", "radius
or diameters", "mm/min. or mm/rev", etc. selected by machine parameter.
Coordinate preset
It must be done on one axis at a time and proceeding as follows:
The CNC requests confirmation of the command.
Axis feedrate (F)
To set the axis feedrate, key in:
Jog movement
Besides the continuous, incremental or handwheel jog, it is also possible to move the axes to a
programmed position.
It is done on one axis at a time. With the feedrate «F» and % currently selected. To do that, press:
ooValue
Value
ooValue