Installation manual
CNC 8055
CNC 8055i
CONFIGURABLE WORK MODE
16.
SOFT: V02.2X
·611·
Spindle control
16.3 Spindle control
The CNC displays the following information:
1. Real spindle speed in rpm.
2. Theoretical spindle speed in rpm or m/min (ft/min) when working at Constant Surface Speed
(CSS).
To select another speed, press:
The CNC assumes this value and if the spindle is turning, it updates the real spindle speed (in
rpm).
3. Spindle status and % of spindle speed being applied.
4. Maximum spindle rpm (T model).
To select another speed, press:
5. Spindle gear currently selected.
This value cannot be changed when using an automatic gear change.
To change gears, press
Note: When the machine does not use spindle gears, this message makes no sense. That is why
the CNC does not show this message when text 28 of program 999997 has not been defined.
Value
The CNC highlights the current value.
Value The CNC assumes this value and does not allow the spindle to exceed these rpm.
and until the new value is highlighted.
Gear number o
To Next Page
Loading...
