Installation manual
CNC 8055
CNC 8055i
CONFIGURABLE WORK MODE
16.
SOFT: V02.2X
·613·
Screens, subroutines and cycles
16.5 Screens, subroutines and cycles
User Fagor’s WINDRAW55 (PC based) application to define the screens
Screens 201 through 255 must be used to customize the screens already stored at the CNC.
Screens 001 through 200 may be used to create new screens for diagnosis, variable consultation,
setup, adjustments, device control, OEM canned cycles, etc.
Regardless of how they are used, screens 001 through 200 the have associated with them.
• The configuration file P999xxx (P999001 through P999200) that must be defined by the OEM.
• The subroutine that contains the executable 9xxx (9001 through 9200) that must be defined by
the OEM.
• Program P999995 that contains the texts used by all the screens. Refer to the WINDRAW55
manual.
• Program P999994 that contains the help texts used by all the screens. Refer to the WINDRAW55
manual.
Thus, the configuration file P999004 and subroutine 9004 are associated with screen 4.
When pressing [HELP] , the CNC shows all the screens defined by the OEM with the WINDRAW55
application.
To delete any of them, position the cursor on it and press [CLEAR].
The CNC requests confirmation and the access code for customizing, if the OEM has previously
defined it.
To access one of the screens 001 through 2000, position the cursor on it and press [ENTER].
Screens 201 through 255 cannot be accessed from this mode. Select the CNC screen associated
with it.
In the WINDRAW55 application, the text for to the screen title should be defined with the same number
as the screen.
This way, when pressing, the key [HELP], CNC will show the number and title (text of program P999995
with the same number) of the available screens.
To Next Page
Loading...
