·618·
Installation manual
CNC 8055
CNC 8055i
16.
CONFIGURABLE WORK MODE
SOFT: V02.2X
OEM text in several languages.
• Texts associated with screens and symbols generated with program Draw55.
Key in the text and press ENTER.
Assign to it the number of one of the internal CNC texts.
Assign to it the number of one of the OEM texts defined in the [OEMMSG] group. New option
that is selected with the F2 softkey (OEM TEXT).
Note: This type of texts can only be displayed properly at the CNC. The Draw55 application
shows OEMtxtnn where "nn" means the number of the associated text; for example OEMtxt25.
The OEM screens or cycles are created with the WINDRAW55 application.
The texts used by the application are created in the WINDRAW55.txt program and must be copied
to the CNC as program P999995 or as part of the MSGFILE program within the [CO999995] group.
Use the Draw55 application to generate symbols or drawings used by those screens. If the texts
of the symbols depend on the language, define them as part of the MSGFILE within the [OEMMSG]
group.
Notes:
On power-up or after a Shift-Reset, the CNC runs the following checkl to find the work texts of each
group or text type:
• It takes the group of the MSGFILE program if it has been defined in the selected language.
• If it is not defined, it takes the texts of the first group defined (another language).
• If there is none, it takes the texts of program PLCMSG, PLCERR, P999995 or P999994
It then looks for texts in those groups.
To Next Page
Loading...
