Fagor CNC 8055i FL EN - Page 622

·622·
Installation manual
CNC 8055
CNC 8055i
16.
CONFIGURABLE WORK MODE
SOFT: V02.2X
Configuration file
;(TEACHIN W5=POSX)
Permits assigning the value of a CNC variable to the data.
In this case, While the W5 data is selected, when pressing the Recall key, W5 will show the variable
of POSX (X axis position). If Enter is then pressed, the cycle assumes this value.
;(FORMAT W7,INCH)
The value is shown in the work units (mm / inches) set by general parameter INCHES (P8).
;(PROFILE W12)
Permits associating a profile with the (W) field. The field must be an unsigned 3-digit integer.
Select the (W) field, enter the number of the profile to be edited, press Recall and it will access the
profile editor.
The edited profile is stored as program P994xxx.
P994001 corresponds to profile 001, P994002 to 002 and so on up to P994999 that corresponds
to profile 999.
;(P100=W13)
Permits assigning the value of the (W) data to a global parameter only when calling a subroutine.
When executing a cycle, the CNC calls the associated subroutine indicating with local parameters
which values have been defined in each field. For example:
(PCALL 9001, A10, B12, C5, D8)
When using global parameters, the CNC uses another PCALL instruction to transfer the global
parameters. For example:
(PCALL 9301, P100=22, P101=32, P102=48)
(PCALL 9001, A10, B12, C5, ... Y8, Z100)
When using a (P100=W13) type instruction, the auxiliary subroutine must also be defined even if
it only contains the SUB and RET instructions.
;(W1=GUP100)
Associates the value of a global parameter with the (W) data.
;(W2=PLCFRO)
Associates the value of a variable with the (W) data.
;(W3=PLCR127)
Associates the value of a PLC resource with the (W) data.
Associate only resources that are defined in the PLC program.
For marks, inputs and outputs, one must indicate how many of them, if none is indicated, 32 are
assigned.
;(W6=PLCO11,4) Assigns the value of O11, O12, O13, O14
;(W6=PLCO11) Assigns the value of O11, O12 ... O41, O42.
The subroutine associated with the cycle is 9000 + cycle number
The auxiliary subroutine associated with the cycle is 9300 + cycle number
A register ;(W6=PLCR127)
A mark ;(W6=PLCM1000,1) first and how many
A group of inputs ;(W6=PLCI8,4) first and how many
A group of outputs ;(W6=PLCO10,3) first and how many