·626·
Installation manual
CNC 8055
CNC 8055i
16.
CONFIGURABLE WORK MODE
SOFT: V02.2X
Cycle data entry
16.12 Cycle data entry
Once the cycle has been selected, the CNC shows the relevant screen. It may have a blue frame
at the top right indicating the current status of the machine. Coordinates and machining conditions:
One of the data that define the cycle will be highlighted indicating that it is selected.
Select a numeric data
The numeric data is used for coordinates, feedrate, spindle speed, tool number, etc. (value in
WINDRAW55).
If this [Recall] key is not available, send the key code $F006 (61446) from the PLC to the CNC.
The following example shows how to use an external push button connected to input I25 so as to
act like the [Recall] key.
Select an option among the ones available
It is used to select a button in a group of WINDRAW55 buttons.
Use the keys to select another data
Key in the desired value and press
If the Teachin instruction is associated with it, the value of an
internal variable (coordinate, tool number, etc.) may be
assigned to this field. In those cases, press
( ) = MOV 0 R100 = MOV 1 R101 = MOV $F006 R102
Initializations.
DFU I27
Every time the external key is pressed...
= CNCWR(R101, KEYSRC, M1)
... it indicates to the CNC that the keys come from the PLC.
= CNCWR(R102, KEY, M1)
... the code for the Recall key is sent out.
= CNCWR(R100, KEYSRC, M1)
... and it indicates to the CNC that the keys come from the CNC.
Use the keys
To Next Page
Loading...
