Installation manual
CNC 8055
CNC 8055i
CONFIGURABLE WORK MODE
16.
SOFT: V02.2X
·627·
Cycle data entry
Select one of the representations in an icon
It is used to select an icon in a multiple representation of WINDRAW55.
When pressing [ESC], the top of the screen shows a CYCLE START icon. It is then possible to:
• press [ESC] again to exit the cycle.
• Press the [Start] key. It calls the associated subroutine (9001) to execute the cycle.
Press the key or send the key code $F01D (61469) from the PLC to the CNC until the
desired icon or text appears.
To Next Page
Loading...
