·628·
Installation manual
CNC 8055
CNC 8055i
16.
CONFIGURABLE WORK MODE
SOFT: V02.2X
Example. Consult inputs and outputs
16.13 Example. Consult inputs and outputs
It uses the 005 screen. The data shown by this screen have the following identifier (W).
This screen has the P999005 configuration file associated with it which is defined as follows:
;(PRGSCRIPT 1)
Header and version.
The debugging of the configuration file begins.
;(DEBUG)
Starting at this line, program 999500 keeps a log of the errors originated when debugging the
configuration file.
;(DISABLE 1)
The blue frame at the top right of the screen is not to be displayed.
;(AUTOREFRESH W1=PLCI1,1)
Refreshes (updates periodically) the value of graphic element W1 assigning the value of input I1
to it. Repeat this instruction for all the inputs.
;(AUTOREFRESH W31=PLCO1,1)
Refreshes (updates periodically) the value of graphic element W31 assigning the value of output
O1 to it. Repeat this instruction for all the outputs.
;(FORMAT W61,LEDBARDEC)
;(AUTOREFRESH W61=ANAO1)
Refreshes (updates periodically) the value of the W61 ledbar assigning the value of analog output
1 (X axis analog voltage) to it. Repeat this instruction for all three axes.
;(END)
End of the debugging of the configuration file and end of program.
Since this screen does not belong to a cycle, its associated subroutine (9005) needs not be defined.
Inputs I1 through I30 W1 through W30
Outputs O1 through O30 W31 through W60
X, Y, Z axis (spindle) output W61, W62, W63
To Next Page
Loading...
