·64·
Installation manual
CNC 8055
CNC 8055i
1.
8055 CNC CONFIGURATION
SOFT: V02.2X
Monitors
Enclosure
The minimum distance from each side of the monitor to its enclosure in order to guarantee the
required ambient conditions is shown below:
When using a fan to better ventilate the enclosure, a DC FAN must be used since an AC fan may
generate electromagnetic interference resulting in distorted images being displayed by the CRT.
The temperature inside the enclosure must be between 0 and 50ºC (32ºF and 122ºF).
50(1.97)
50(1.97)
50(1.97)
5
0
(1
.
9
7
)
5
0
(
1
.
9
7
)
Do not manipulate the inside of the unit. Only personnel authorized by Fagor Automation may access
the interior of this unit.
Do not handle the connectors with the unit connected to AC power. Before manipulating these
connectors, make sure that the unit is not connected to main AC power.
To Next Page
Loading...
