Fagor CNC 8055i FL EN - Appendix; Technical Characteristics of the 8055 Icnc

Installation manual
CNC 8055
CNC 8055i
A.
SOFT: V02.2X
·645·
Technical characteristics of the 8055iCNC
TECHNICAL CHARACTERISTICS OF THE 8055iCNC
General characteristics
4 feedback inputs for the axes.
4 analog outputs to control the axes (±10 V).
1 feedback input for the spindle encoder.
1 analog output to control the spindle (±10 V).
2 feedback inputs for the electronic handwheels.
2 inputs for digital probes (TTL or 24 V DC).
Digital servo or CAN.
0.0001mm or 0.00001 inch resolution.
Multiplying factor up to x 25 with sinewave input.
Feedrate from 0.0001 to 99999.9999 mm/min (0.00001 - 3937 inches/min).
Maximum travel: ±99999.9999 mm (±3937 inches).
1 RS232C communication line.
56 optocoupled digital inputs
32 optocoupled digital outputs
Remote modules for digital I/O expansion.
32-bit processor
Math coprocessor
Graphics coprocessor.
1Mb CNC program memory.
3.5 ms block processing time , FL model.
0.9 ms block processing time, POWER model.
Sampling time configurable by the machine manufacturer; 2, 3, 4, 5 and 6 ms.
Approximate weight 7.5 Kg.
Maximum consumption of 60 W in normal operation.
Color monitor
Technology: Color TFT LCD.
Diagonal display area dimension: 10,4”.
Resolution: VGA 3 x 640 x 480 pixels.
Number of colors: 262144 Colors (6 bit for each subpixel RGB).
Backlit with 2 cold-cathode fluorescent lamps.
Power
The machine manufacturer must comply with the EN 60204-1 (IEC-204-1) standard in terms of
protection against electrical shock due to faulty contacts with external power supply.
This unit MUST NOT be opened by unauthorized personnel.
To avoid overheating the internal circuitry, do not block the ventilation grooves and install a ventilation
system that removes the hot air from the enclosure.
Due to the current state of the COLOR TFT LCD technology, all manufacturers accept the fact the LCD
screens have a certain number of defective pixels.
Rated voltage: 20 V minimum and 30 V maximum.
Ripple: 4 V.
Nominal current: 2 A.
Current peak on power-up: 8 A.
The figure shows the shape of the supply current on power-up