Installation manual
CNC 8055
CNC 8055i
C.
SOFT: V02.2X
·653·
11" LCD Monitor
11" LCD MONITOR
Monitor
Technology: Color TFT LCD.
Diagonal display area dimension: 10,4”.
Resolution: VGA 3 x 640 x 480 pixels.
Number of colors: 262144 Colors (6 bit for each subpixel RGB).
Backlit with 2 cold-cathode fluorescent lamps.
Power
Universal AC Power supply 84-264 Vac
Mains frequency: 50 - 60 Hz ±1.
Consumption: 20 W in normal operation and 3W in low consumption.
Connectors
Monitor supply: Bipolar connection base + ground connection, according to IEC-320 and EEC-22 standards.
Video signals: 25 pin SUB-D connector (male).
Keyboard connection: 25 pin SUB-D connector (female).
Packaging
Meets EN 60068-2-32 standard.
Ambient conditions
Relative humidity: 20% ÷ 80%.
Operating temperature: between +5 ºC (41 ºF) and +40 ºC (104 ºF) with an average under +35 ºC (95 ºF).
Storage temperature: between -25 ºC (-4 ºF) and +70 ºC (158 ºF)
Maximum work altitude: IEC 1131-2 compliant.
Electromagnetic compatibility and Safety
Refer to the section on safety conditions in the introduction of this manual.
Protection degree
Front panel: IP54.
Rear panel: IP2X.
Accessible parts inside: IP1X.
The machine manufacturer must comply with the EN 60204-1 (IEC-204-1) standard in terms of
protection against electrical shock due to faulty contacts with external power supply.
This unit MUST NOT be opened by unauthorized personnel.
To avoid overheating the internal circuitry, do not block the ventilation grooves and install a ventilation
system that removes the hot air from the enclosure.
To Next Page
Loading...
