Installation manual
CNC 8055
CNC 8055i
E.
SOFT: V02.2X
·657·
Probe connection at the 8055 CNC
PROBE CONNECTION AT THE 8055 CNC
-Vpp axes and –Vpp SB Axes– module
The CNC has two probe inputs (of 5Vdc and 24Vdc) at connector X7 of the –Vpp Axes– module
and the -Vpp SB- module.
Depending on the type of connection applied the general parameter "PRBPULSE" (P39) must be
set, indicating whether it operates with the leading edge or trailing edge of the signal which the probe
provides.
Probe with "normally open contact" output.
Probe with "normally closed contact" output
Interface with an open-collector output. Connection to +5 V
Interface with an open-collector output. Connection to +24 V
Interface with a PUSH-PULL output
Acts with an up-flank.
Acts with an up-flank.
Acts with a down flank.
Acts with a down flank.
The active flank depends on the
interface used
To Next Page
Loading...
