·666·
Installation manual
CNC 8055
CNC 8055i
F.
SOFT: V02.2X
Summary of internal CNC variables.
TANGAN R R R Angular position with respect to the path (G45).
TPIOUT(X-C) R R R Output of the PI of the tandem master axis in rpm.
DNCSTA - R - DNC transmission status.
TIMEG R R R Remaining time to finish the dwell block (in hundredths of a second)..
SELPRO R/W R/W R When having two probe inputs, it selects the active input.
DIAM R/W R/W R It changes the programming mode for X axis coordinates between radius
and diameter.
PRBMOD R/W R/W R Indicates whether a probing error must be displayed or not.
RETREJ R/W R/W R It indicates that the drilling, mill or lathe type withdrawal iscompleted.
RIP - - - Linear theoretical feedrate resulting from the next loop (in mm/min).
TEMPIn R R R It returns the temperature in tenths of a degree detected by the PT100.
TIPPRB R R R PROBE cycle being executed.
PANEDI R R R WINDRAW55 application. Number of screen being executed.
DATEDI R R R WINDRAW55 application. Number of element (item) being executed.
RIGIER R R R Offset between the projection of the following error of the spindle onto the
longitudinal axis and the following error of the longitudinal axis.
FBDIF(X-C) R R R For monitoring the difference between the coordinates (position values) of
the first and second feedback on the oscilloscope.
CYCLEV R R R It indicates on the conversational model, the tab number being displayed
at a particular moment.
CYCEDI R R R It indicates on the conversational model, the cycle or screen number being
displayed at a particular moment.
DISBLO R R R It indicates the value of the total programmed distance in blocks with look-
ahead.
MIXPO(X..C) R R R Variable that indicates the axis position with the combined feedback.
FLWAC(X..C) R R R Variable that indicates the real error considering the second feedback.
RADIOC R - - It indicates the programmed radius value when executing a G15 R.
DISABMOD R R/W R Disables some actions or modes.
CYCCHORDERR R/W - - Defines the chordal error of the canned cycles.
PRGN R R R Returns the program number being executed.
EXECLEV R R R Indicates the EXEC level that is in execution at the time.
Variable CNC PLC DNC
( section 13.18 )
The "KEY" variable can be "written" at the CNC only via the user channel.
The "NBTOOL" variable can only be used within the tool change subroutine.
To Next Page
Loading...
