·668·
Installation manual
CNC 8055
CNC 8055i
G.
SOFT: V02.2X
Summary of PLC commands
Simple consulting instructions
Flank detecting consulting instructions
Comparison consulting instructions
Operators
Assignment Binary Action Instructions
Conditioned binary actions instructions
I 1/512 Inputs
O 1/512 Outputs
M 1/5957 Marks
T 1/512 Timers
C 1/256 Counters
B 0/31 R 1/499 Register bit
DFU (Up flank detection)
DFD (Down flank detection)
I 1/512
O 1/512
M 1/5957
CPS T 1/256
C 1/256
R 1/559
#
GT
GE
EQ
NE
LE
LT
T 1/256
C 1/256
R 1/559
#
NOT Inverts the result of the consulting instruction it precedes.
AND Performs the logic function "AND" between consulting instructions.
OR Performs the logic function "OR" between consulting instructions.
XOR Performs the logic function "EXCLUSIVE OR" between consulting instructions.
= I 1/512 Inputs.
= O 1/512 Outputs.
= M 1/5957 Marks.
= TEN 1/256 Timer enable.
= TRS 1/256 Timer reset.
= TGn 1/256 n/R Timer trigger input.
= CUP 1/256 Counter count up.
= CDW 1/256 Counter count down.
= CEN 1/256 Counter enable.
= CPR 1/256 n/R Counter preset.
= B 0/31 R 1/499 Register Bits.
= SET If the logic expression is "1", this action assigns a "1" to the resource.
= RES If the logic expression is "1", this action assigns a "0" to the resource.
= CPL If the logic expression is "1", this action complements the logic state of the resource.
= SET
= RES
= CPL
I 1/512
O 1/512
M 1/5957
B 0/31 R 1/559
To Next Page
Loading...
