Installation manual
CNC 8055
CNC 8055i
H.
SOFT: V02.2X
·673·
Summary of PLC inputs and outputs
Spindle logic inputs.
Logic inputs of the auxiliary spindle
Key inhibiting logic inputs.
Logic inputs of the PLC channel
Main Second
LIMIT+S M5450 LIMIT+S2 M5475 Travel limit overrun. Stops the axes and the spindle.
Displays the error.
LIMIT -S M5451 LIMIT -S2 M5476 Travel limit overrun. Stops the axes and the spindle.
Displays the error.
DECELS M5452 DECELS2 M5477 Home switch pressed.
SPDLEINH M5453 SPDLEIN2 M5478 Outputs a zero command for the spindle.
SPDLEREV M5454 SPDLERE2 M5479 Reverses the spindle turning direction.
SMOTOFS M5455 SMOTOFS2 M5480 Cancels the SMOTIME filter, spindle parameter
SMOTIME (P46).
SERVOSON M5457 SERVOSO2 M5482 Servo signal. (=1) to move the spindle in closed loop
(M19).
GEAR1 M5458 GEAR12 M5483 Spindle gear 1 selected.
GEAR2 M5459 GEAR22 M5484 Spindle gear 2 selected.
GEAR3 M5460 GEAR32 M5485 Spindle gear 3 selected.
GEAR4 M5461 GEAR42 M5486 Spindle gear 4 selected.
SPENAS M5462 SPENAS2 M5487 With Sercos. Speed enable signal of the drive.
DRENAS M5463 DRENAS2 M5488 With Sercos. Drive enable signal of the drive.
PLCFM19 M5464 PLCFM192 M5489 Rapid synchronization feedrate, in M19.
M19FEED R505 M19FEED2 R507 Rapid synchronization feedrate, in M19.
PLCCNTL M5465 PLCCNTL2 M5490 Spindle controlled directly by the PLC.
SANALOG R504 SANALOG2 R506 Spindle velocity command. Only for spindle
controlled by PLC.
ELIMIS M5456 ELIMIS2 M5481 The CNC does not display the spindle although it
keeps controlling it.
SPENAAS M5449 With Sercos. Speed enable signal of the drive.
DRENAAS M5448 With Sercos. Drive enable signal of the drive.
PLCCNTAS M5056 The auxiliary spindle is controlled directly by the PLC.
SANALOAS R509 Velocity command for the auxiliary spindle. Only for spindle controlled by PLC.
ELIMIAS M5062 The CNC does not display the spindle although it keeps controlling it.
KEYDIS1 R500 Inhibit the operation of the panel keys.
KEYDIS2 R501
KEYDIS3 R502
KEYDIS4 R503
/FEEDHOP M5004 Stops the PLC axes momentarily, maintaining spindle rotation.
/XFERINP M5005 Prevents the next block from being executed in the PLC channel, but finishes the one
being executed.
AUXENDP M5006 Indicates that the execution of the M, S and T functions has completed.
BLOABORP M5061 Possibility to abort the PLC channel
To Next Page
Loading...
