·674·
Installation manual
CNC 8055
CNC 8055i
H.
SOFT: V02.2X
Summary of PLC inputs and outputs
General logic outputs.
CNCREADY M5500 CNC without errors.
START M5501 The CYCLE START key of the front panel has been pressed.
FHOUT M5502 Indicates that program execution has been interrupted.
RESETOUT M5503 Indicates that the CNC is set to initial conditions.
LOPEN M5506 Indicates that the positioning loop for the axes is open.
/ALARM M5507 An alarm or emergency condition was detected.
MANUAL M5508 The manual operation (JOG) mode has been selected.
AUTOMAT M5509 The automatic operation mode has been selected.
MDI M5510 The MDI mode has been selected.
SBOUT M5511 The single block execution mode has been selected.
CUSTOM M5512 Selected work mode (=0) M or T; (=1) MC, MCO, TC or TCO
INCYCLE M5515 The part program is being executed.
RAPID M5516 A rapid traverse is being executed (G00).
TAPPING M5517 A tapping cycle is being executed (G84).
THREAD M5518 A threading block is being executed (G33).
PROBE M5519 A probing movement is being executed (G75/G76).
ZERO M5520 A machine reference search is being executed (G74).
RIGID M5521 A rigid tapping block in execution. Milling model.
RETRAEND M5522 Retrace function. All possible blocks have been retraced.
CSS M5523 The G96 function is selected.
SELECT0 M5524 Position selected at the front panel switch.
SELECT1 M5525 Position selected at the front panel switch.
SELECT2 M5526 Position selected at the front panel switch.
SELECT3 M5527 Position selected at the front panel switch.
SELECT4 M5528 Position selected at the front panel switch.
SELECT5 M5529 Position selected at the front panel switch.
SELECT6 M5530 Position selected at the front panel switch.
SELECT7 M5531 Position selected at the front panel switch.
SELECTOR R564 Position selected at the front panel switch.
MSTROBE M5532 Indicates that the auxiliary M functions which are indicated in registers R550 to R556
must be executed.
SSTROBE M5533 Indicates that the auxiliary S function of register R557 must be executed.
TSTROBE M5534 Indicates that the auxiliary T function of register R558 must be executed.
T2STROBE M5535 Indicates that the auxiliary T function of register R559 must be executed.
S2MAIN M5536 Indicates which spindle is controlled by the CNC.
ADVINPOS M5537 For punch presses, it indicates that punching may begin.
INTEREND M5538 It indicates that the interpolation is finished.
INPOS M5539 The axes are in position.
DM00 M5547 Program interrupted after executing the auxiliary function M00.
DM01 M5546 Program interrupted after executing the auxiliary function M01.
DM02 M5545 The execution of the program has stopped after executing the auxiliary M02 function.
DM03 M5544 The spindle is turning clockwise (M03).
DM04 M5543 The spindle is turning counterclockwise (M04).
DM05 M5542 The spindle is stopped (M05).
DM06 M5541 The auxiliary M06 function has been executed.
To Next Page
Loading...
