·70·
Installation manual
CNC 8055
CNC 8055i
1.
8055 CNC CONFIGURATION
SOFT: V02.2X
Operator panel
Dimensions and elements of the KS50/55
X1 25-pin female SUB-D type (normal density) connector to connect the "central unit + monitor".
X2 25-pin female SUB-D type (normal density) connector to connect the "alphanumeric
keyboard + monitor".
X3 SUB-D type 25-pin female connector to connect with the operator panel.
X4 3-pin male Phoenix connector, 7,62 mm pitch, to select the keyboard to be attended by the
central unit.
If connector X4 is not supplied with voltage, the CNC attends to the operator panel.
The maximum cable length allowed between the "central unit + monitor" and the "operator panel"
or "alphanumeric keyboard" is 25 m (82 ft).
When using 2 keyboards, a keyboard switching board must be installed.
Here are some examples for keyboard selection.
With a switcher.
With two switchers.
Pin Value Meaning
10 V
24 V
The CNC attends to the operator panel.
The CNC attends to the alphanumeric keyboard.
2
3
- - -
11
Not used.
External power supply.
To Next Page
Loading...
