Fagor CNC 8055i FL EN - Page 74

·74·
Installation manual
CNC 8055
CNC 8055i
2.
CNC 8055 I CONFIGURATION
SOFT: V02.2X
CNC structure
Operator panels with integrated monitor
All these keyboards have an auto-identification system. See "Keyboard auto-identification" on page
74.
Independent monitors
Independent operator panels
MC, TC and MCO/TCO operator panels can have an optional alphanumeric keyboard where each
key has a single letter or number assigned to it (KB-40/55-ALFA). This keyboard is connected to
the operator panel through the KS 50/55 adapter.
All these keyboards have an auto-identification system. See "Keyboard auto-identification" on page
74.
Keyboard auto-identification
Certain keyboard models have a auto-identification system. With this type of keyboards, parameter
CUSTOMTY is updated automatically; for the rest of the keyboards, this parameter must be set
manually.
If the keyboard does not match the CNC model, it shows the relevant error message and it loads
the key codes that correspond to the CNC model. For example, if a mill model keyboard is connected
to a lathe CNC, the keyboard is set for a lathe and the CNC shows the error message.
CNC 8055i FL-GP-K CNC 8055i Power-GP-K
CNC 8055i FL-M-K CNC 8055i Power-M-K
CNC 8055i FL-MC-K CNC 8055i Power-MC-K
CNC 8055i FL-T-K CNC 8055i Power-T-K
CNC 8055i FL-TC-K CNC 8055i Power-TC-K
CNC 8055i FL-GP CNC 8055i Power-GP
CNC 8055i FL-M CNC 8055i Power-M
CNC 8055i FL-T CNC 8055i Power-T
M model OP-8055-ALFA operator panel
T model OP-8055-ALFA operator panel
MC model OP-8055-MC operator panel
TC model OP-8055-TC operator panel
MCO/TCO model OP-8055-MCO/TCO operator panel