Installation manual
CNC 8055
CNC 8055i
CNC 8055 I CONFIGURATION
2.
SOFT: V02.2X
·77·
CNC structure
2.1.1 Connectors
The connectors are located in the rear of the CNC.
(A) Power supply.
(B) Ground connection.
(C) To connect the USB hard disk (Pen Drive) or USB extension cable.
(D) Communications board
(E) Compact flash memory with the CNC configuration (KeyCF).
(F) To connect the keyboard signal.
(G) To connect the USB extension cable to the keyboard.
X1 For RS232 serial line connection.
X2 For digital I/O connection (I1 through I16 and O1 through O8).
X3 For probe connection.
X4 For analog spindle connection.
X5 For electronic handwheel connection.
X6 For Operator Panel connection.
X7 For digital I/O connection (I97 to I104 and O33 to O56).
X8 For axis velocity command connection.
X9 For digital input connection (I65 to I96).
X10 For feedback connection of the first axis.
X11 For feedback connection of the second axis.
X12 For feedback connection of the third axis.
X13 For feedback connection of the fourth axis.
Do not manipulate the inside of the unit. Only authorized personnel from Fagor Automation may do it.
Do not handle the connectors with the unit connected to main AC power. Before manipulating these
connectors, make sure that the unit is not connected to main AC power.
The machine manufacturer must comply with the EN 60204-1 (IEC-204-1) standard in terms of
protection against electrical shock due to faulty I/O contacts with external power supply.
To Next Page
Loading...
