·84·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
General machine parameters. Execution channels.
HSCDEFAULMODE
Default mode when programming #HSC ON.
Possible values: SURFACE / CONTERROR / FAST.
Default value: SURFACE.
Associated variable: (V.)[ch].MPG.HSCDEFAULMODE
Default mode to activate HSC machining.
VIRTUAL TOOL AXIS.
A virtual axis of the tool is a fictitious axis that always moves in the direction in which the tool
is oriented. The purpose of the virtual tool is to facilitate the movement in the direction of the
tool when it is not aligned with with the axes of the machine. This way and depending on the
applied kinematics, it will move the corresponding X Y Z axes so the tool moves along its
axis. This function facilitates drilling operations, withdrawing the tool in its direction as well
as increasing or decreasing the depth of the pass while machining a part.
VIRTAXISNAME
Virtual tool axis name.
Possible values: Any valid axis name; X, X1··X9, ·· , C, C1··C9.
Default value: none.
Associated variable: (V.)[ch].MPG.VIRTAXISNAME
Name identifying the virtual axis of the tool.
The virtual tool axis must be a linear axis, must belong to the channel and cannot be part
of the main trihedron when it is active. Since it is an axis of the channel, it may be moved
like any other axis in the various work modes: automatic, jog, tool inspection, axis
repositioning, etc. The virtual tool axis has travel limits that may be set by machine parameter
and by program.
VIRTAXCANCEL
Automatic cancellation of the virtual tool axis after an M30 and
Reset.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPG.VIRTAXCANCEL
This parameter indicates whether the CNC cancels or not the virtual tool axis after executing
an M02/M30 and after a reset.
DEFAULT CONDITIONS (CHANNEL).
The following parameters indicate the conditions assumed by the channel on power-up, after
executing an M02 or M30 or after a reset.
KINID
Default kinematics number.
Possible values: From 0 to 6 or nothing.
Default value: Nothing (the CNC does not assume any kinematics on power-up).
Associated variable: (V.)[ch].MPG.KINID
This parameter indicates the kinetics number (not type) active by default. If set to ·0·, on
power-up the CNC restores the kinematics that was active when it was turned off. If no value
is set, the CNC does not activate any kinematics by default.
There can be up to 6 different kinematics defined at the CNC. To select another kinematics
from the part-program, use the #KIN ID instruction.
To Next Page
Loading...
