Operating manual.
CNC 8060
CNC 8065
AUTOMATIC MODE
4.
Tool inspection.
·105·
(REF: 1807)
Manual tool calibration.
Tool inspection also allows accessing manual tool calibration. Once the tool has been
calibrated, exit tool inspection, the CNC requests repositioning the axes before resuming
program execution. The softkey to access tool calibration will be different depending on the
software installed (lathe model or mill model). See "6.1 Manual calibration. Calibration
without a probe" on page 133.
Resuming the execution of the program.
Once all the axes are repositioned or after canceling repositioning, press [START] to resume
program execution.
• If tool inspection has ended by repositioning all the axes, when pressing [START], the
CNC completes the interrupted path and goes on with the rest of the program.
• If tool inspection has ended after canceling the repositioning of the axes, when pressing
[START], the axes move from their current position to the end point of the interrupted path
and then the CNC goes on with the rest of the program.
Softkey. Type of calibration.
Tool calibration in a mill model.
Tool calibration in a lathe model.
To Next Page
Loading...
