Fagor CNC 8060 - Page 122

Operating manual.
CNC 8060
CNC 8065
5.
MANUAL (JOG) MODE
Operations with the axes.
·122·
(REF: 1807)
Movement in continuous jog.
In continuous jog, the axes keep moving while the jog keyboard is acted upon. Continuous
jog allows moving several axes at the same time.
1 Turn the jog selector switch of the operator panel to the continuous jog position on the dial.
2 Jog the desired axis using the JOG panel (keypad). If while moving, a second axis is
selected and either the '+' key or the '-' key is pressed, the CNC stops the first axis and
de-selects it. The new axis stays selected and moves according to the pressed '+' key
or '-' key.
Movement in incremental jog.
In incremental jog, the axis moves a specific distance every time the key is pressed. In
incremental jog, the axes may be jogged simultaneously.
1 Turn the jog selector switch of the operator panel to one of the incremental jog positions.
Each position will move the axis a fixed distance; the typical values are the following.
2 Jog the desired axis using the JOG panel (keypad). Every time the JOG panel is acted
upon, the axis will move the distance indicated on the dial of the jog selector switch. If
while moving, a second axis is selected, the new one will move at the same time and
under the same conditions.
If while the axes are moving, the rapid key is pressed, the axes will move at the rapid rate
set by the machine manufacturer. This feedrate will be applied while that key is kept pressed
and, when released, the axes will recover their previous feedrate. This rapid rate may be
varied between 0% and 200% with the feedrate override switch on the operator panel.
Position. Movement for each key push.
1 0.001 mm or 0.0001 inch.
10 0.010 mm or 0.0010 inches.
100 0.100 mm or 0.0100 inches.
1000 1.000 mm or 0.1000 inches.
10000 10.000 mm or 1.0000 inches.