Operating manual.
CNC 8060
CNC 8065
8.
EDISIMU MODE (EDITING AND SIMULATION)
Working in the editing window.
·184·
(REF: 1807)
Tangential entry and exit.
Square, semi-rounded or rounded corner.
Plane change.
This softkey may be used to define a tangential entry or exit. In either case,
the cycle shows the necessary data to define the machining operation.
The cycle internally generates an ISO block with function G37 or G38.
This softkey may be used to define the type of corner, round, semi-round
or sharp. If necessary, the cycle shows the necessary data to define the
type of corner.
The cycle internally generates an ISO block with function G05, G50 or
G07.
This softkey may be used to define the work plane, be it a main one (G17,
G18 or G19) or one defined by two axes (G20).
The cycle internally generates an ISO block with function G17, G18, G19
or G20.
To Next Page
Loading...
