Operating manual.
CNC 8060
CNC 8065
8.
EDISIMU MODE (EDITING AND SIMULATION)
Working in the program window.
·188·
(REF: 1807)
8.8 Working in the program window.
8.8.1 Select the first and last blocks of the execution.
Set beginning.
This option sets as starting block for simulation the block selected with the cursor. When not
setting the first block, the simulation will begin at the first block of the program.
The first block may be selected using the cursor or the "Find text" option of the softkey menu.
The selected block stays active until canceled (selecting another block or selecting the same
one again) or simulating the program.
Stop condition.
This option sets the block where the simulation of the program or subroutine will be
interrupted. After executing that block, the execution may be resumed with the [START] icon
or canceled with the [RESET] icon. If no last block is established, the simulation of the
program will end after executing one of the end-of-program functions "M02" or "M30".
Select subroutine.
This option selects the stop condition in a global subroutine which has been called upon from
the program. When selecting this option, the CNC shows a list of the available subroutines.
After selecting the desired subroutine, it will appear in the program window.
Set stop block.
This option sets as simulation interruption block the block selected with the cursor. If no last
block is established, the simulation of the program will end after executing one of the end-
of-program functions "M02" or "M30".
The last block may be selected using the cursor or the "Find text" option of the softkey menu.
The selected block stays active until canceled (selecting another block or selecting the same
one again) or executing the program.
Number of times.
This option sets as stop condition, that the block selected as the last block has been executed
a specific number of times.
When selecting this option, the CNC requests the number of times that the block must be
executed before ending the execution of the program. After entering the number of times,
press [ENTER] to validate the value or [ESC] to cancel it.
Find text.
This option shows a dialog box for placing the cursor on a particular line of the program or
search for text or a character string in the program.
Go to line.
In this area of the dialog box, the CNC requests the line number to go to. Key in the desired
number and press [ENTER], the cursor will then go to that line.
After selecting the "block selection" softkey, the horizontal softkey menu shows the following
options. To return to the main menu, press the [BACK] key.
Softkey. Description.
Set beginning First block for execution or for manual block search.
Stop condition. Set the condition to end the execution or the manual block
search.
Find text. Find text
To Next Page
Loading...
