Operating manual.
CNC 8060
CNC 8065
11.
PROFILE EDITOR
Modify a profile and insert corners
·216·
(REF: 1807)
Once the type of corner to be inserted has been selected, the CNC will highlight in red one
of the corners of the profile. Use the softkey menu or the following keys to select another
element of the profile or select a corner of another profile.
After selecting the corner of the profile to be modified and the CNC will request the value
(radius or size) of the corner.
• For a rounding, enter the rounding radius.
• For a chamfer, enter the size of the chamfer.
• For a tangential entry, enter the entry radius.
• For a tangential exit, enter the exit radius.
After defining the value of the corner, press [ENTER] to insert the corner in the profile. Then,
one may select another corner or quit this mode by pressing [ESC].
Additional ISO.
This softkey may be used to add an ISO coded line to a previously closed profile. Once the
ISO coded line to be added has been entered, confirm the command by pressing the
[ENTER] key.
Key. Meaning.
Select the corners of the profile.
Select a corner of another profile.
When the profile is part of a conversational canned cycle, the CNC ignores the feedrate (F)
programmed in the additional ISO lines. The CNC uses the feedrates set in the canned cycle.
To Next Page
Loading...
