Operating manual.
CNC 8060
CNC 8065
13.
GRAPHICS HD (·M· MODEL).
Configure the colors for the tool path and solid.
·242·
(REF: 1807)
13.6 Configure the colors for the tool path and solid.
Path colors.
This option is used to assign colors to the following tool paths.
• Rapid traverse (G0).
• Compensated movements.
• Uncompensated movements.
• Canned cycles.
• Tapping.
Part colors.
This option is used to change the background colors, the colors of the machined areas and
the look of the part. The selected values remain until the CNC is turned off.
• Background color.
• Color of the machining operations carried out with the first five tools used on the graphic.
Here only the colors are defined, to display them, the "view tool colors" option must be
active in the properties of the view.
• Material used to represent the solid part. The "Advanced" button may be used to change
the properties of the selected material. Besides the various color components (diffuse,
ambient, etc.), the brightness and transparency of the part can also be defined.
Transparency may take values between 0 and 1. If the value of the transparency is other
than zero, the solid part becomes transparent.
This softkey is used to configure the colors for the part and for the tool paths. This
configuration is global for all the windows.
To Next Page
Loading...
