Operating manual.
CNC 8060
CNC 8065
GRAPHIC ENVIRONMENT (LATHE MODEL)
14.
Dimensions
·257·
(REF: 1807)
14.4 Dimensions
It is used to define the size of the graphic representation by setting the inside and outside
diameters of the part and the maximum and minimum coordinates of the graphics on the
longitudinal axis.
Dimensions "Automatic"
The CNC sets the dimensions that it considers best according to the movements
programmed.
Dimensions "Edit"
The CNC lets manually edit the dimension values. It is edited in the dialog area of the graphic
window that shows the dimensions of the graphics.
14.5 Measurement
This softkey may be used to measure the distance between two points. This option is not
available in the "Combined" type of graphics.
When selecting this option, the section being measured will appear on the graphics with two
cursors and a dashed line. The cursor currently selected will appear in red.
The dialog area will show the coordinates of both cursors, the distance between them on
the straight line and the components of that distance on the axes of the active plane. The
coordinates of the selected cursor will appear in red.
Measurement "Point1" & "Point2"
This option is used to select the cursor to be moved (same as using the [+] key).
Measurement "Edit"
This option is used to manually edit the position of the cursors. It is edited in the dialog area
of the graphic window that shows the position of both cursors.
When selecting this option, the softkey menu shows the options available for setting the
dimensions. To return to the main menu, press the [BACK] key.
Key. Meaning.
To move the zoom frame around.
To change the size of the zoom frame.
When selecting this option, the softkey menu shows the available options. To return to the
main menu, press the [BACK] key.
To Next Page
Loading...
