Fagor CNC 8060 - MDI;MDA Mode; Interface Description

CNC 8060
CNC 8065
16
·279·
(REF: 1807)
MDI/MDA MODE
The MDI mode lays over all the other work modes in such a way that when quitting the MDI
mode by pressing [ESC], the CNC goes into the work mode from where the MDI mode was
accessed.
The channel does not allow accessing its MDI/MDA mode if a program is being executed
in the same channel, except when it is interrupted. The blocks executed while a program
is interrupted alter the history of the program and these changes are maintained when
resuming the execution.
16.1 Interface description.
Standard window (MDI).
This window only shows the edit line of the MDI mode. In the MDI window, it is possible to
edit and execute new blocks or recover blocks saved in the block history, which may be
modified before executing them.
A Window for the MDI mode (Edit line) where the blocks to be executed are edited. Blocks
are edited one by one.
Full screen (MDA).
This window shows the blocks saved so far and the edit line of the MDI mode. It is possible
to edit and execute new blocks or recover blocks saved in the block history, which may be
modified before executing them.
A History of blocks in MDI mode. Every time a new block is edited, it is added to this history.
B Edit line where the blocks to be executed are edited. Blocks are edited one by one.
A
B
A