Operating manual.
CNC 8060
CNC 8065
TOOL AND MAGAZINE TABLE
18.
Tool and tool magazine table.
·307·
(REF: 1807)
"R" - Tool radius
This data is only shown on tools that are not for turning. The dimensions of the turning tools
are defined with the offsets.
"LW" "RW" - Tool length and radius wear
Tool radius wear and length wear offset. The CNC adds the wear value to the nominal length
and radius to calculate the real tool length (L + LW) and real tool radius (R + RW).
In the tool table, it is possible to define whether the wear value being entered must be
incremental or absolute. In either case, deleting the wear value or setting it to 0 implies
resetting the amount of wear to 0. See
"Select the type of wear values to enter, incremental
or absolute." on page 309.
Using incremental wear, the value entered by the user will be added (or subtracted if it is
negative) to the absolute value of the wear. After pressing [ENTER] to accept the new value,
the wear field will show the resulting absolute value.
"A" - Cutter angle
This data is only shown for turning tools. For the grooving and cut-off tool, this data assumes
a value of 90º.
"C" - Cutting angle
This data is only shown for turning tools. For the grooving and cut-off tool, this data assumes
a value of 90º.
"B" - Cutter width
This data is only shown for turning tools.
L Tool length.
R Tool radius.
Lc Cutting length.
Initial length Wear Final length
50 0.2 50.2
50 -0.2 49.8
-50 0.2 -49.8
-50 -0.2 -50.2
Initial wear Incremental wear Total wear
10.21.2
1-0.20.8
-1 0.2 -0.8
-1 -0.2 -1.2
A Cutter angle.
C Cutting angle.
BCutter width.
Lc Cutting length.
To Next Page
Loading...
