Operating manual.
CNC 8060
CNC 8065
20.
PLC
"Programs" service
·344·
(REF: 1807)
20.2.1 Softkey menus. PLC project.
These options are used to create a PLC project and compile it to create the executable PLC
program.
PLC project "Generate PLC"
This option compiles and loads the PLC program based on the files that make up the PLC
project. If an error occurs during compilation, the program will not be generated and the CNC
will display a list of the detected errors.
The proper compilation of a file in mnemonic language or contact (ladder) language
generates the equivalent files in both languages. That is why two files having the same name
and different extension cannot belong to the same project because, when compiled, they
are the same file.
PLC project "Add file"
This option is used to add a file to the PLC project. This file may be a new one or an existing
one. When selecting this option, the CNC shows a list of the available files. To add a file to
the PLC project.
1 Select the file from the list or write its name in the bottom window.
2 Press [ENTER] to accept the selection and add the file or [ESC] to cancel the selection
and close the file listing.
When accepting the selection, the selected file will appear on the list that make up the PLC
project.
Softkey. Description.
Compile the PLC project to create the executable program.
Add a file to the PLC project.
Add a library to the PLC project.
To Next Page
Loading...
