Fagor CNC 8060 - Parameter Table Description

Operating manual.
CNC 8060
CNC 8065
MACHINE PARAMETERS
21.
Parameter table description
·389·
(REF: 1807)
21.2 Parameter table description
The machine parameter tables have the following structure:
A Name of the selected machine parameter table.
B Parameter list.
C Parameter value, set by the user.
D Units used to define the parameter.
E Limit values for the parameter.
F Default value of the parameter.
G Parameter description.
The section on
"21.3.1 Data editing and validation" in this chapter shows how to edit the
parameters of the tables. Certain parameters cannot be edited; they only access a set of
parameters or a data table. These parameters will be identified as follows.
To access the data associated with the parameter, select the parameter with the cursor and
press [ENTER]. To return to the previous parameter table, press [ESC].
To access a group of parameters.
To access a data table.
A
B C D E F
G
To obtain further information about the data appearing in the table, refer to the chapter on machine
parameters of the installation manual.
i