Operating manual.
CNC 8060
CNC 8065
23.
DDSSETUP
List of devices connected to the bus.
·436·
(REF: 1807)
number of files does not match the number of elements in the bus, the CNC will warn about
it and it will give the option to either resume or abort the process.
Update the descriptor of the parameters and variables (only Sercos).
In Mechatrolink devices, not all the parameters assume the new values immediately, sometimes, the
servo needs to be restarted so it assumes the new values. Refer to the documentation of the devices
to know when the servos assume the new values.
Softkey. Function.
Update the descriptor of the parameters and variables.
In a Sercos bus, this softkey updates file that describes the parameters and
variables of the drive.
To Next Page
Loading...
