Fagor CNC 8060 - Page 446

Operating manual.
CNC 8060
CNC 8065
23.
DDSSETUP
Command line.
·446·
(REF: 1807)
23.9 Command line.
Operations with a Sercos device.
• Consult and modify the variables of the drive. To read a variable, edit its name and press
[ENTER]. To write a variable, assign a value to it and press [ENTER].
Read-only variables may be consulted (those with the "R" indicator on the attributes
column). Read-write variables may be consulted and/or edited (those with the "RW"
indicator on the attributes column). See
"23.4 –Parameters and variables– service." on
page 438.
Variables may be identified using their mnemonic or their Sercos identifier. Refer to the
drive's manual to know the list of available variables.
If not indicated otherwise, the DDSSetup accesses the variables of the drive selected
in the service. To access those of a particular drive, select it in the service or add a suffix
with the axis name to the mnemonic (or Sercos ID).
• Execute commands of the drive.
The drop list offers the following commands. To execute one of them, select it from the
list and press [ENTER].
Operations with a Mechatrolink device.
• Consult variables. Edit the name of the variable and press [ENTER].
The range of available variables is MLINK0 to MLINKF and they will be associated with
the devices through their name (MLINK7.X) or through the node number (MLINK7.1). If
the variable does not indicate any device, the CNC associates with it the device active
at the DDSSetup.
The command line is located at the bottom of all the services of the DDSSetup. The command
line may be used to consult variables, read and write parameters, obtain information on the
status of the device and insert variables in the monitoring window.
PV210 Consulting the PV210 variable.
S36 Consulting the variable SV1 (Sercos ID = 36).
RV9 = 23 It assigns the value of 23 to the variable RV9.
S36 = 100 It assigns the value of 100 to variable S36 (Sercos ID = 36).
PV210.Y It consults the variable PV210 of the Y axis drive.
S36.S Consulting variable (Sercos ID = 16) of the spindle drive.