CNC 8060
CNC 8065
24
·451·
(REF: 1807)
DIAGNOSIS
The diagnosis is a testing and displaying tool; it cannot be used to modify the displayed
values. This operating mode may be used to test the hardware and software of the PC that
the CNC is based upon.
• System information.
• Information about the modules that make up the CNC software.
• Information about the elements connected to the CNC through the CAN bus, Sercos or
Mechatrolink.
24.1 Appearance of the diagnosis mode.
The diagnosis screen shows the following information.
A CNC hardware and software configuration.
System diagnosis: Information on the system elements; CNC version, user name,
microprocessor(s) used, status of the various system memories, etc.
Software diagnosis: Information about the modules that make up the CNC software and
the software options installed.
Hardware diagnosis: Information about the elements connected to the CNC through the
Can bus, Sercos (drives, input/output cards, etc.) and Mechatrolink (servos and
inverters).
B Diagnosis of the selected element.
C CNC messages.
To Next Page
Loading...
