·336·
Installation manual
CNC 8060
CNC 8065
6.
LOGIC CNC INPUTS AND OUTPUTS.
(REF: 1402)
Keystroke modifiable signals.
Registers KEYLED2 / KEYLED2_1 to KEYLED2_8.
KEYDIS1 / KEYDIS2 / KEYDIS3 / KEYDIS4
These registers inhibit (bit=1) the keys and the switches on all operator panels at the same
time.
KEYDIS1_1 / KEYDIS2_1 / KEYDIS3_1 / KEYDIS4_1
··
KEYDIS1_8 / KEYDIS2_8 / KEYDIS3_8 / KEYDIS4_8
These registers inhibit (bit=1) the keys and the switches on each operator panel. Registers
KEYDIS1_1 to KEYDIS4_1 correspond to the first jog panel, KEYDIS1_2 to KEYDIS4_2 to
the second one and so on.
When selecting one of the inhibited positions of the feedrate override, the CNC will take the
value of the lowest position allowed. If all of them are inhibited, it will take the value of 0%.
For example, being allowed only the 110% and 120% positions, if the 50% position is
selected, the CNC will take the value of 0%.
When selecting one of the inhibited positions of the spindle speed override, the CNC will take
the value of the lowest position allowed. If all the positions are inhibited, the CNC keeps the
active value.
Bit Key Bit Key
0 Spindle override + 16 - - -
1 Spindle clockwise 17 - - -
2 Spindle positioning 18 - - -
3 Spindle stop 19 - - -
4 Spindle override - 20 - - -
5 Spindle counterclockwise 21 - - -
6 START 22 - - -
7STOP 23 - - -
8 - - - 24 - - -
9 - - - 25 - - -
10 - - - 26 - - -
11 ZERO 27 - - -
12 - - - 28 - - -
13 Single block 29 - - -
14 - - - 30 - - -
15 RESET 31 - - -
The following instruction inhibits the first jog key (bit 16) of the second keyboard.
( ) = B16KEYDIS1_2
To Next Page
Loading...
