Installation manual
CNC 8060
CNC 8065
TOOL AND MAGAZINE MANAGEMENT.
7.
(REF: 1402)
·369·
Synchronous magazine without changer arm.
7.8.1 Valid operations and marks activated by the PLC with each one of them.
Valid operations of the tool manager for this magazine.
The possible operations in this type of magazine are:
Values of registers TAKEPOS and LEAVEPOS used by the
manager.
The TAKEPOS and LEAVEPOS signals can assume the following values.
Here is a summary table of the TAKEPOS and LEAVEPOS values used by the manager in
each operation as well as the marks that must be activated by the PLC at the end of each
operation.
TMOPERATION Meaning.
0 Do nothing.
1 Take a tool from the magazine and insert it in the spindle.
2 Leave the spindle tool in the magazine.
3 Insert a ground tool in the spindle.
4 Leave the spindle tool on the ground.
5 Leave the spindle tool in the magazine and take a tool from the same
magazine.
6 Leave the spindle tool in the magazine and take a tool from ground.
7 Leave the spindle tool on the ground and take a tool from the magazine.
8 Leave the spindle tool on the ground and take a tool from ground.
9 Take a ground tool to the magazine going through the spindle.
10 Take a tool from the magazine and leave on the ground going through the
spindle.
11 Orient the magazine.
12 Leave the spindle tool in the magazine and take a tool from the same
magazine (as TMOPERATION=5). It is an optimized operation, only valid
when the magazine is random and the tool is special.
13 Orienting two magazines.
14 Leave the spindle tool in the magazine and take a tool from another
magazine.
Value Meaning
0 Do nothing.
# Magazine position.
-4 Ground tool.
TM => PLC PLC => TM
TMOPERATION TAKEPOS LEAVEPOS
1#0 MZTOSPDL
20# SPDLTOMZ
300 GRTOSPDL
400 SPDLTOGR
5 # # SPDLTOMZ + MZTOSPDL
6 -4 # SPDLTOMZ + GRTOSPDL
7 # -4 SPDLTOGR + MZTOSPDL
8 0 0 SPDLTOGR + GRTOSPDL
9 -4 # GRTOSPDL + SPDLTOMZ
To Next Page
Loading...
