Fagor CNC 8065 - Detailed Description of the Operations of the Magazine

Installation manual
CNC 8060
CNC 8065
TOOL AND MAGAZINE MANAGEMENT.
7.
(REF: 1402)
·371·
Synchronous magazine without changer arm.
7.8.2 Detailed description of the operations of the magazine.
Here is a sample of a detailed description of the valid operations for this magazine. For each
operation, it indicates which of the TAKEPOS, LEAVEPOS, NEXTPOS and MZID signals are
involved and their meanings. It also shows the sequence to follow to complete the operation.
The TAKEPOS, LEAVEPOS and NEXTPOS signals can assume the following values.
TMOPERATION = 1
Take a tool from the magazine and insert it in the spindle.
The sequence of this operation is the following.
1 After ending this operation, activate the MZTOSPDL mark.
TMOPERATION = 2
Leave the spindle tool in the magazine.
The sequence of this operation is the following.
1 After ending this operation, activate the SPDLTOMZ mark.
TMOPERATION = 3
Insert a ground tool in the spindle.
The sequence of this operation is the following.
1 When the operation is completed, activate the mark: GRTOSPDL.
TMOPERATION = 4
Leave the spindle tool on the ground.
The sequence of this operation is the following.
1 When the operation is completed, activate the mark: SPDLTOGR.
TMOPERATION = 5
Leave the spindle tool in the magazine and take a tool from the same magazine.
The sequence of this operation is the following.
1 Leave the tool of the spindle in the magazine and activate the mark SPDLTOMZ.
2 Leave the tool of the magazine in the spindle and activate the mark MZTOSPDL.
TMOPERATION = 6
Leave the spindle tool in the magazine and take a tool from ground.
The sequence of this operation is the following.
1 Leave the tool of the spindle in the magazine and activate the mark SPDLTOMZ.
2 Leave the ground tool in the spindle and activate the mark GRTOSPDL.
Value Meaning
0 Do nothing.
# Magazine position.
-4 Ground tool.
TAKEPOS=# Magazine position to pick up the tool.
LEAVEPOS=# Magazine position to leave the tool.
TAKEPOS=# Magazine position to pick up the tool.
LEAVEPOS=# Magazine position to leave the tool.
TAKEPOS=-4 Ground tool.
LEAVEPOS=# Magazine position to leave the tool.