Fagor CNC 8065 - Page 372

·372·
Installation manual
CNC 8060
CNC 8065
7.
TOOL AND MAGAZINE MANAGEMENT.
(REF: 1402)
Synchronous magazine without changer arm.
TMOPERATION = 7
Leave the spindle tool on the ground and take a tool from the magazine.
The sequence of this operation is the following.
1 Leave the tool of the spindle on the ground and activate the mark SPDLTOGR.
2 Leave the tool of the magazine in the spindle and activate the mark MZTOSPDL.
TMOPERATION = 8
Leave the spindle tool on the ground and take a tool from ground.
The sequence of this operation is the following.
1 Leave the tool of the spindle on the ground and activate the mark SPDLTOGR.
2 Leave the ground tool in the spindle and activate the mark GRTOSPDL.
TMOPERATION = 9
Take a ground tool to the magazine going through the spindle.
The sequence of this operation is the following.
1 Leave the ground tool in the spindle and activate the mark GRTOSPDL.
2 Leave the tool of the spindle in the magazine and activate the mark SPDLTOMZ.
TMOPERATION = 10
Take a tool from the magazine and leave on the ground going through the spindle.
The sequence of this operation is the following.
1 Leave the tool of the magazine in the spindle and activate the mark MZTOSPDL.
2 Leave the tool of the spindle on the ground and activate the mark SPDLTOGR.
TMOPERATION = 11
Orient the magazine.
This operation is an optimization of the tool change that permits orienting the magazine while
machining. Activate the MZROT mark to indicate that the operation has been completed,
whether it has been oriented or not.
TMOPERATION = 12
Leave the spindle tool in the magazine and take a tool from the same magazine (as
TMOPERATION=5). It is an optimized operation, only valid when the magazine is random
and the tool is special.
TMOPERATION = 13
Orienting two magazines.
TAKEPOS=# Magazine position to pick up the tool.
LEAVEPOS=-4 Ground tool.
TAKEPOS=-4 Ground tool.
LEAVEPOS=# Magazine position to leave the tool.
TAKEPOS=# Magazine position to pick up the tool.
LEAVEPOS=-4 Ground tool.
TAKEPOS=# Magazine position to pick up the tool.
LEAVEPOS=# Magazine position to leave the tool.