·378·
Installation manual
CNC 8060
CNC 8065
7.
TOOL AND MAGAZINE MANAGEMENT.
(REF: 1402)
Synchronous magazine without changer arm.
$CASE 10
Take a tool from the magazine and leave on the ground going through the spindle.
LL SUB_SPD_AUTCHG
Move the spindle to the automatic tool change point
LL SUB_MZ_TO_SPD
Take the tool from the magazine to the spindle.
LL SUB_SPD_GMCHG
Move the spindle to the manual tool change point.
LL SUB_SPD_TO_GR
Remove the tool from the spindle.
$BREAK
$ENDSWITCH
End of analysis of type of operation.
$WHILE V.TM.MZWAIT == 1
$ENDWHILE
Wait for the tool manager.
#RET
End of M06 subroutine.
To Next Page
Loading...
