Fagor CNC 8065 - Detailed Description of the Operations of the Magazine

·398·
Installation manual
CNC 8060
CNC 8065
7.
TOOL AND MAGAZINE MANAGEMENT.
(REF: 1402)
Synchronous magazine with changer arm and 2 claws.
7.10.2 Detailed description of the operations of the magazine.
Here is a sample of a detailed description of the valid operations for this magazine. For each
operation, it indicates which of the TAKEPOS, LEAVEPOS, NEXTPOS and MZID signals are
involved and their meanings. It also shows the sequence to follow to complete the operation.
The TAKEPOS, LEAVEPOS and NEXTPOS signals can assume the following values.
TMOPERATION = 1
Take a tool from the magazine and insert it in the spindle.
The sequence of this operation is the following.
1 Take the tool from the magazine with holder 1 and activate the mark MZTOCH1.
2 Insert the tool of holder 1 in the spindle and activate CH1TOSPDL.
TMOPERATION = 2
Leave the spindle tool in the magazine.
The sequence of this operation is the following.
1 Take the tool from the spindle with holder ·2· and activate the mark SPDLTOCH2.
2 Leave the tool of holder ·2· in the magazine and activate the mark CH2TOMZ.
TMOPERATION = 3
Insert a ground tool in the spindle.
The sequence of this operation is the following.
1 When the operation is completed, activate the mark: GRTOSPDL.
TMOPERATION = 4
Leave the spindle tool on the ground.
The sequence of this operation is the following.
1 When the operation is completed, activate the mark: SPDLTOGR.
TMOPERATION = 5
Leave the spindle tool in the magazine and take a tool from the same magazine.
The sequence of this operation is the following. The tool manager also admits the sequences
1-2-4-3, 2-1-3-4, 2-1-4-3.
1 Take the tool from the spindle with holder ·2· and activate the mark SPDLTOCH2.
2 Take the tool from the magazine with holder 1 and activate the mark MZTOCH1.
3 Leave the tool of holder ·2· in the magazine and activate the mark CH2TOMZ.
4 Insert the tool of holder 1 in the spindle and activate CH1TOSPDL.
TMOPERATION = 6
Leave the spindle tool in the magazine and take a tool from ground.
Value Meaning
0 Do nothing.
# Magazine position.
-4 Ground tool.
TAKEPOS=# Magazine position to pick up the tool.
LEAVEPOS=# Magazine position to leave the tool.
TAKEPOS=# Magazine position to pick up the tool.
LEAVEPOS=# Magazine position to leave the tool.
TAKEPOS=-4 Ground tool.
LEAVEPOS=# Magazine position to leave the tool.