Installation manual
CNC 8060
CNC 8065
TOOL AND MAGAZINE MANAGEMENT.
7.
(REF: 1402)
·399·
Synchronous magazine with changer arm and 2 claws.
The sequence of this operation is the following. The tool manager admits the sequence 1-3-2.
1 Take the tool from the spindle with holder ·2· and activate the mark SPDLTOCH2.
2 Leave the tool of holder ·2· in the magazine and activate the mark CH2TOMZ.
3 Leave the ground tool in the spindle and activate the mark GRTOSPDL.
TMOPERATION = 7
Leave the spindle tool on the ground and take a tool from the magazine.
The sequence of this operation is the following. The tool manager admits the sequence 2-1-3.
1 Leave the tool of the spindle on the ground and activate the mark SPDLTOGR.
2 Take the tool from the magazine with holder 1 and activate the mark MZTOCH1.
3 Insert the tool of holder 1 in the spindle and activate CH1TOSPDL.
TMOPERATION = 8
Leave the spindle tool on the ground and take a tool from ground.
The sequence of this operation is the following.
1 Leave the tool of the spindle on the ground and activate the mark SPDLTOGR.
2 Leave the ground tool in the spindle and activate the mark GRTOSPDL.
TMOPERATION = 9
Take a ground tool to the magazine going through the spindle.
The sequence of this operation is the following.
1 Leave the ground tool in the spindle and activate the mark GRTOSPDL.
2 Take the tool from the spindle with holder ·2· and activate the mark SPDLTOCH2.
3 Leave the tool of holder ·2· in the magazine and activate the mark CH2TOMZ.
TMOPERATION = 10
Take a tool from the magazine and leave on the ground going through the spindle.
The sequence of this operation is the following.
1 Take the tool from the magazine with holder 1 and activate the mark MZTOCH1.
2 Insert the tool of holder 1 in the spindle and activate CH1TOSPDL.
3 Leave the tool of the spindle on the ground and activate the mark SPDLTOGR.
TMOPERATION = 11
Orient the magazine.
This operation is an optimization of the tool change that permits orienting the magazine while
machining. Activate the MZROT mark to indicate that the operation has been completed,
whether it has been oriented or not.
TMOPERATION = 12
Leave the spindle tool in the magazine and take a tool from the same magazine (as
TMOPERATION=5). It is an optimized operation only valid in the following types of
synchronous magazine.
• Non-random having a tool changer arm with two claws.
TAKEPOS=# Magazine position to pick up the tool.
LEAVEPOS=-4 Ground tool.
TAKEPOS=-4 Ground tool.
LEAVEPOS=# Magazine position to leave the tool.
TAKEPOS=# Magazine position to pick up the tool.
LEAVEPOS=-4 Ground tool.
To Next Page
Loading...
