Fagor CNC 8065 - Page 413

Installation manual
CNC 8060
CNC 8065
TOOL AND MAGAZINE MANAGEMENT.
7.
(REF: 1402)
·413·
Asynchronous magazine with changer arm.
First sequence:
1 Take the tool from the spindle with holder ·2· and activate the mark SPDLTOCH2.
2 Leave the tool of holder ·2· in the magazine and activate the mark CH2TOMZ.
3 Insert the tool of holder 1 in the spindle and activate CH1TOSPDL.
Second sequence:
1 Take the tool from the spindle with holder ·2· and activate the mark SPDLTOCH2.
2 Insert the tool of holder 1 in the spindle and activate CH1TOSPDL.
3 Start sending the changer arm to the magazine to leave the tool in holder 2.
4 When the arm leaves the collision zone, activate TCHANGEOK, if so desired, to continue
executing the program.
5 Leave the tool of holder ·2· in the magazine and activate the mark CH2TOMZ.
TMOPERATION = 6
Leave the spindle tool in the magazine and take a tool from ground.
In this operation, the tool manager admits 2 sequences.
First sequence:
1 Take the tool from the spindle with holder ·2· and activate the mark SPDLTOCH2.
2 Leave the tool of holder ·2· in the magazine and activate the mark CH2TOMZ.
3 Leave the ground tool in the spindle and activate the mark GRTOSPDL.
Second sequence:
1 Take the tool from the spindle with holder ·2· and activate the mark SPDLTOCH2.
2 Leave the ground tool in the spindle and activate the mark GRTOSPDL.
3 Start sending the changer arm to the magazine to leave the tool in holder 2.
4 When the arm leaves the collision zone, activate TCHANGEOK, if so desired, to continue
executing the program.
5 Leave the tool of holder ·2· in the magazine and activate the mark CH2TOMZ.
TMOPERATION = 7
Leave the spindle tool on the ground and take a tool from the arm.
The sequence of this operation is the following. Previously, while machining (when executing
the T) the manager sends the code: TMOPERATION=11 to take the tool from the magazine
with claw 1.
1 Leave the tool of the spindle on the ground and activate the mark SPDLTOGR.
2 Insert the tool of holder 1 in the spindle and activate CH1TOSPDL.
TMOPERATION = 8
Leave the spindle tool on the ground and take a tool from ground.
The sequence of this operation is the following.
1 Leave the tool of the spindle on the ground and activate the mark SPDLTOGR.
2 Leave the ground tool in the spindle and activate the mark GRTOSPDL.
TMOPERATION = 9
Take a ground tool to the magazine going through the spindle.
TAKEPOS=-4 Ground tool.
LEAVEPOS=# Magazine position to leave the tool.
TAKEPOS=-1 Tool in the changer arm.
LEAVEPOS=-4 Ground tool.
TAKEPOS=-4 Ground tool.
LEAVEPOS=# Magazine position to leave the tool.