Fagor CNC 8065 - Page 445

Installation manual
CNC 8060
CNC 8065
CONCEPTS.
9.
(REF: 1402)
·445·
Configure the name and number of axes and spindles.
LATHE WITH 3 CHANNELS, 6 AXES AND 2 SPINDLES.
CONFIGURATION OF "PLANE" TYPE AXES.
The axes and spindles are distributed as follows.
General configuration of the channels, axes and spindles.
Configuration of the axes and spindles of the system.
Configuration of the axes and spindles of channel ·1·.
Configuration of the axes and spindles of channel ·2·.
Configuration of the axes and spindles of channel ·3·.
Plane selection in channels ·1· and ·2·.
With this configuration, the work plane is always G18 and will be formed by the first two axes
defined in the channel. If the X (firs axis of the channel) and Z (second axis of the channel)
have been defined, the work plane will be the ZX (Z as abscissa and X as ordinate). Functions
G17 and G19 are not valid. Since there are only two axes, function G20 makes no sense.
Channel ·1·. 2 axes (X Z) 1 spindle (S).
Channel ·2·. 2 axes (X1 Z1) 1 spindle (S1).
Channel ·3·. 2 axes (U V)
System Channel ·1· Channel ·2· Channel ·3·
NCHANNEL = 3 GEOCONFIG = Plane GEOCONFIG = Plane
NAXIS = 6 CHNAXIS = 2 CHNAXIS = 2 CHNAXIS = 2
NSPDL = 2 CHNSPDL = 1 CHNSPDL = 1 CHNSPDL = 0
IPLANE = G18 IPLANE = G18
AXISNAME Value Logic order. Index in the system.
AXISNAME 1 X Logic number ·1·.
AXISNAME 2 Z Logic number ·2·.
AXISNAME 3 X1 Logic number ·3·.
AXISNAME 4 Z1 Logic number ·4·.
AXISNAME 5 U Logic number ·5·.
AXISNAME 6 V Logic number ·6·.
SPDLNAME 1 S Logic number ·7·. Spindle with index ·1·.
SPDLNAME 2 S1 Logic number ·8·. Spindle with index ·2·.
CHAXISNAME Value Index in the channel. Logic order.
CHAXISNAME 1 X Axis with index ·1·. Logic number ·1·.
CHAXISNAME 2 Z Axis with index ·2·. Logic number ·2·.
CHSPDLNAME Value Index in the channel. Logic order.
CHSPDLNAME 1 S Spindle with index ·1·. Logic number ·7·.
CHAXISNAME Value Index in the channel. Logic order.
CHAXISNAME 1 X1 Axis with index ·1·. Logic number ·3·.
CHAXISNAME 2 Z1 Axis with index ·2·. Logic number ·4·.
CHSPDLNAME Value Index in the channel. Logic order.
CHSPDLNAME 1 S1 Spindle with index ·1·. Logic number ·8·.
CHAXISNAME Value Index in the channel. Logic order.
CHAXISNAME 1 U Axis with index ·1·. Logic number ·5·.
CHAXISNAME 2 V Axis with index ·2·. Logic number ·6·.