Installation manual
CNC 8060
CNC 8065
CONCEPTS.
9.
(REF: 1402)
·465·
Multi-axis management.
Number of the feedback input for the axis.
Depending on the type of feedback, this parameter indicates which feedback input will be
used (either local or remote) or the drive number. When two axes will not be in the
configuration at the same time, the CNC allows using the same feedback input for both axes.
Type of feedback. Number of the feedback input for the axis.
Feedback input in CANfagor
remote modules.
A counter module is used as feedback input in the remote modules.
This parameter indicates the number of the feedback input being
used.
The counter modules are numbered following the logic order of the
remote groups (rotary switch of the power supply). If there are
several Counter modules in each group, the order is from top to
bottom and from left to right. The counters of the first module will be
1 through 4, those of the second module 5 through 8 and so on.
Feedback input in Sercos
drives.
In this case, the second feedback input of the drive will always be
used. The parameter indicates the logic address of the drive (from
1 to 32). The "address" rotary selector switch sets the logic address.
Local feedback input. The central unit has two feedback inputs. This parameter indicates
the feedback input being used.
To Next Page
Loading...
