Installation manual
CNC 8060
CNC 8065
CONCEPTS.
9.
(REF: 1402)
·483·
Configure a handwheel as "feed handwheel".
CPS R103 LT 0 = SBS 0 R103 R103
CPS R103 GT 120 = MOV 120 R103
Adjust the value of register R103; ignore the handwheel turning direction (sign) and
limit the value to 120%.
DFU CLK100
= CNCWR (R103,PLC.FRO, M1001)
Use the up flank at the clock CLK100 to set the calculated feedrate override value.
L101
END
To Next Page
Loading...
